rmankty31
Plastic
- Joined
- Aug 30, 2012
- Location
- Michigan USA
Hello,I was initiated into machining in 1976-77 by operating turret lathes,primarily Warner&Swasey.Most of them were #2 or#3,some had bar feed.The one I learn to set up lathes on was one with bar feed,which I set-up and operated for about 3 years.Altogether I was in machining for about 5.5 years,mostly on turret lathes and engine lathes.Can you tell me when W&S stopped manufacturing the smaller models? I am seriously planning to start a shop in the pole barn,and I thought that for my initial purposes I might get a #2,3,or 4 and make parts for my tractor.I want to say I have always thought that the W&S' were the best of all I ran during that time.Thank you for your reply!