What's new
What's new

Warner&Swasey M1200 issues

elysianfield

Cast Iron
Joined
Feb 28, 2007
Location
Myrtle Point, Oregon USA
Hello again,
I have what appears to have been a recently refitted #3 Turret machine, Lot 351, Sn 1038482, that through misuse, has a damaged the master collet. The collet uses #4 pads, and is a bit smaller than the "standard" #4 Master. My Master collet ID at the rear of the master measures 1.812". My question... is this a common retrofit on the #3's, and does any one in the readership have a master collet of the dimension I need that they might sell?
 








 
Back
Top