Hello,
I would like to make an angle plate with a chuck attached to it.
I need to have a hole in the middle of the plate, a gun drill will go from behind to long bore a blank of wood.
Any advise will be appreciated.
Thank you,
The video will describe this much easier:
(video deleted since poster did not respond to answer to his Q. This site does not intend to support drive-by spammers attempting to build traffic elsewhere) smt
I would like to make an angle plate with a chuck attached to it.
I need to have a hole in the middle of the plate, a gun drill will go from behind to long bore a blank of wood.
Any advise will be appreciated.
Thank you,
The video will describe this much easier:
(video deleted since poster did not respond to answer to his Q. This site does not intend to support drive-by spammers attempting to build traffic elsewhere) smt
Last edited by a moderator: