Looking at buying a Haimer but I really dont like the fact that I need to pass the zero point twice to get on center. I feel like my workers will eventually find a way to go to zero once and then set the origin wrong. Has anybody made this mistake or is it not worth worrying about?
I saw this model from haff-schneider and you just go to zero and set it and done. I like this idea much better. But nobody talks about these? Are they as good as the Haimers? Where can I buy these? 3D Measuring Sensor Analogue | Haff & Schneider
Any others worth looking at? Is there a model from Haimer that works like this?
I saw this model from haff-schneider and you just go to zero and set it and done. I like this idea much better. But nobody talks about these? Are they as good as the Haimers? Where can I buy these? 3D Measuring Sensor Analogue | Haff & Schneider
Any others worth looking at? Is there a model from Haimer that works like this?