2006 mits fa10s odd threading issue

[plastikdreams]

So just recently...like yesterday, our fa10s will not return the pipe to the up position after threading. It will go back up on a failed threading event though.

So far my only workaround is to hit stop and then start.

Anyone have any ideas on this?

 

[Artefx]

I've believe I've had this issue before.

It was a broken or loose wire / connection on the wire sensor on the rear cutting head. From what I remember there was a wire with an eyelet that had simply undone itself over time.

 

[plastikdreams]

I've believe I've had this issue before.

It was a broken or loose wire / connection on the wire sensor on the rear cutting head. From what I remember there was a wire with an eyelet that had simply undone itself over time.

Ok thanks, ill take a look!

 

[plastikdreams]

I didn't see or feel any wires back there. Are they under a cover or anything?