Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Recent content by Bohicaman
-
B
HELP, Indicating a vice, on a X/Y Table which is built into a Rotary Table
Thanks to all!! With your comments I was able to figure it out. Will post some pictures as the build advances! B. -
B
HELP, Indicating a vice, on a X/Y Table which is built into a Rotary Table
Just saw the comment about a better picture. Thanks for your other comments too! Here ya go... -
B
HELP, Indicating a vice, on a X/Y Table which is built into a Rotary Table
Interesting idea! Thanks! Bob:scratchchin: -
B
HELP, Indicating a vice, on a X/Y Table which is built into a Rotary Table
Appreciate the info. I'll give it a try very soon! Busy week! -
B
HELP, Indicating a vice, on a X/Y Table which is built into a Rotary Table
Thanks! Hex is a hole with an insert. (newbe's way out! lol) But, as you can see there are advantages to using the Rotary Table. -
B
HELP, Indicating a vice, on a X/Y Table which is built into a Rotary Table
Thanks to all who replied! The part I referenced is the Carriage Block for a .22lR Gatling gun with 10 twelve inch barrels. I need to do a 10 hole bolt circle. Then there multiple flats to mill. Finishing off with some lathe work. There is no hole in the vice, X/Y Table, or Rotary Table to... -
B
HELP, Indicating a vice, on a X/Y Table which is built into a Rotary Table
I'm relatively new to machining. I purchased a Bridgeport Stage I mill that has a YUASA 12" with a 10"x 10" X/Y Table built into it. (Apparently no one I've talked to has ever seen one) There is no hole in the center of the X/Y table. I need to center a piece of round stock in a vice attached to...