Does it do the slowdown even on larger radius arc's (like say a 5" (125 to 130mm) radius or above)or possibly not slow down as much on the larger arcs?
Haha, yeah, no road salt here in Florida! :D
While this car is still technically street legal, it is mainly a track car that is rarely driven on the streets except to car meets from time to time or in the rare even that its the only car I have to drive at the moment and have to get somewhere.
Yeah, I get what you're saying. That photo is just something I found on via Google just to illustrate what I'm looking at making for anyone who is wasn't understanding my explanation. Also, I wasn't planning on Hard Coating them, just regular Type II. I do wonder if the fact that I'll be...
That was part of my thought too. There is enough axial float (0.5mm to be exact) designed in that even if it were to bell / distort a few thou, it shouldn't cause any issues. I'm just concerned of it distorting much more than a few thou.
I am still playing around with ideas for the flip / reflip without loosing positioning. Even if it doesn't distort, I still feel that this would just be extra insurance since I dont like to throw away time or material.
Funny you mention the Wilwood stuff. The is actually to replace Wilwood...
Short back story, most of my experience is in sheet metal and tubular structure fab with little machining from scratch (although have been using a Mill for other work for probably 10 to 12 years now just not much machining complete parts from raw material especially round parts from round...
Our M2 system only has a single FDD (although I did notice that there is a port on the motherboard for a second drive but not sure if its configured to be used by the software or not).
On your system, can you select which drive you want to save on?
If so, then you could most likely replace...
Ok, Got our M2 System to work on the Emulator today! Turned out to be easier than I anticipated too at that.
Parts I used:
Emulator: GOTEK SFR1M44-U100K
from Amazon
Amazon.com: Floppy & Tape Drives-3.5” 1.44MB Sfr1m44-u100k Updated Version USB Flash Disk Floppy Drive Emulator + CD Screws...
I see there was never a Write-up on getting older ProtoTRAK's to work with Emulators.
Short back story, the company I work for (primarily a Welding and sheet metals shop) just picked up an old ProtoTRAK K3 knee mill that has the M2 system on it (mill is in good shape minus a few bearings in the...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.