Largest Manufacturing Technology Community on the Web
Stay Connected:
ClappedOutBport's latest activity
-
CClappedOutBport reacted to jim rozen's post in the thread Pratt & Whitney 12C Restoration Pictures with
Like.
Phenomenal story, phenomenal pictures. Truly amazing machine. One thing I cannot figure out is how P&W ever made *any* money off these... -
CClappedOutBport replied to the thread Two W&S no5’s inbound.You can always do star start. Little bit of extra circuitry, but it's an option.
-
CBy golly they DID cut that sucker down - didn't they? :eek: Back in 1987 Johnny Deere had ads running "The new 4050*, because 4020's...
-
CClappedOutBport reacted to VulcanMachineCo's post in the thread A new cast iron 3 axis challenger weighing in at over 600lbs! with Like.
number 4 and 5 going out monday
-
CMade some progress this week and last. Made some chips! Not picture worthy but they were chips! Super happy moment. Short lived though...
-
CClappedOutBport replied to the thread Two W&S no5’s inbound.Lol. Says the man who outweighed them all with one single lathe! Then he doubled it in the same go!
-
CClappedOutBport replied to the thread Two W&S no5’s inbound.Might have been easier if I got your long chain back to you. Whoops. :o
-
CClappedOutBport replied to the thread Centerless Grinding Adjusting Tips, General and Correcting Hourglass.I ran the machine for about 5 hours today on specialty steel tubes, about 1/2". I have learned a lot in that time. For one, this machine...
-
CApple phone ? Apple thinks it's so cute, when you re-orient a photo instead of actually moving the pixels they just write a note in the...
-
CClappedOutBport replied to the thread Two W&S no5’s inbound.Holy shit dude! Did you ever get that Bradford sold ok? What a success story you had with that thing though, man! WTG.
-
CClappedOutBport reacted to texasgeartrain's post in the thread Pratt & Whitney 12C Restoration Pictures with Like.
I'm so glad to see this thread. Such a nice machine, and P & W make really nice machines. If you don't mind, I'd like to know what of...
-
CI remember how much we all hated VBulletin when we switched over from the (ancient) forum software. And everyone moaned about how those...
-
CBeen 2 days since I got myself a trophy. My palms are starting to itch. Clammy sweats. Gettin' hungry.
-
CClappedOutBport reacted to Chuck Forman's post in the thread FS: Royersford 21" Camelback Drill Press, NC with Like.
Thanks everyone for the very helpful comments/advice. Boring quill went well. Turning spindle ditto. Before I finished this refurbish...
-
CClappedOutBport replied to the thread new format - a thumbs-down.For the record, there has never been a forum software change, anywhere, that has been well received. People are always grumpy, but...