What's new

Recent content by dennishusell

  1. D

    Add bar feeder to program

    Hi Bill Thank you for the indepth explanation. I just tried a short program: G54 G00 Z150 M00 G00 Z10 M99 With the bar feeder turned off, and the M00 did exactly what its supposed to and i had to press cycle start for it to continue. So i would guess that the bar feeder is somehow capable of...
  2. D

    Add bar feeder to program

    Thanks for the input! When using the 1sec time delay after M13, it was behaving exactly like i wanted it. The bar feeder would push right after chuck open, then the toolpost/stop would move back along with the bar to the desired position and execute M12 which would retract the bar feeder push...
  3. D

    Add bar feeder to program

    Hi! Im banging my head against a wall here and really need som help. I recently acquired my first lathe, Preestech TH25F with GSK980TB3i controller and a Fedek DH65L S2 bar feeder(Ive only had mills until now). Its worth mentioning that i bought it from China, so support is.. not exactly up to...
Top