Largest Manufacturing Technology Community on the Web
Stay Connected:
Deude-Mann's latest activity
-
DDeude-Mann replied to the thread Need help with VALENITE MCLNR-12-4 tool holder.So I grabbed a hex wrench and you are right, rotating the lock pin clamped the insert in place. So I presume the clamp is there for...
-
DDeude-Mann replied to the thread Need help with VALENITE MCLNR-12-4 tool holder.Thanks CarbideBob and BT Fab
-
DDeude-Mann reacted to CarbideBob's post in the thread Need help with VALENITE MCLNR-12-4 tool holder with
Like.
Clamp is a NC-2CL..Obsolete but: https://www.ebay.com/itm/265616647776 Clamp screw is a CSC-18 but any screw of the correct thread... -
DDeude-Mann reacted to BT Fabrication's post in the thread Need help with VALENITE MCLNR-12-4 tool holder with Like.
any good tooling rep will have these parts or can easily get them for a couple bucks a part. my local guy got me a bunch for quite a few...
-
DDeude-Mann replied to the thread Need help with VALENITE MCLNR-12-4 tool holder.Here is a side shot of the same tool
-
-
DI have a new (to me) Valenite MCLNR 12-4 turning tool I purchased from Ebay. I did not notice that the clamp and screw that retain the...
-
-
DDeude-Mann replied to the thread Need help identifying Baldor motor (ilder for phase converter).Sorry, I should have said ball bearings.
