What's new

Froneck's latest activity

  • F
    I have a manual in good to poor condition listed as a Series Parts list. Missing cover. First page starts withe page 5 and end with page...
    • CIMG2177.JPG
    • CIMG2178.JPG
  • F
    Froneck replied to the thread Way cover for Gorton MasterMill.
    My desire is to protect the cross feed screw. Ways are in perfect condition and it look like it has way wipers. The mill has square ways...
  • F
    Froneck replied to the thread Way cover for Gorton MasterMill.
    I have 12" rated cross travel, might be a little more but can't check it at this time due to the machines location. However I did move...
  • F
    I picked-up a really nice Gorton MasterMill from HGR some time ago. As with just about everything from HGR there were a few issues.Down...
  • F
    Froneck replied to the thread Chinese DRO quality.
    I really don't want a DRO with all the bells and whistles I will never use. Too many have the face of the DRO with so many buttons it...
  • F
    Froneck replied to the thread Chinese DRO quality.
    Seem odd they don't make them. There are a lot of machines that don't need the bells and whistles like surface grinders and Horz. mills...
  • F
    Froneck replied to the thread Chinese DRO quality.
    I give one a try. I did make an offer on one, they countered but it said it's out of stock. Thought maybe the counteroffer was to me for...
  • F
    Froneck replied to the thread Chinese DRO quality.
    I want a simple DRO with no bells and whistles. I do have a Anilam Wizard on my Jig Borer that came with the machine but never use the...
  • F
    Froneck replied to the thread Chinese DRO quality.
    I have 2 Sony, Anilam and a Sargon that have been working very good, no problem except with last power outage. Sony's still work great...
  • F
    Froneck posted the thread Chinese DRO quality in General.
    I've noticed DROs made in China in ebay cheap! Would be nice to put one one my Horizontal Mill though the dials have served me well. DRO...
  • F
    Is the a Taper cutting device to cut the approx. angle of a Moore tool holder? I purchased 3 Susta brand tool storage holders from HGR...
  • F
    Froneck reacted to CarbideTip's post in the thread Analam Wizard help with Like Like.
    For the Anilam unit the settings are held in a battery-backed memory chip. The battery and chip are all in one package so you cannot...
  • F
    Froneck replied to the thread Analam Wizard help.
    Thanks again Martin. Rereading the manual I see the code I should have used is1000101 in X and 0000101 in Y. Not sure why the last 3...
  • F
    Froneck replied to the thread Analam Wizard help.
    Thanks to Carbide Tip that e-mailed me the manual. I did push #8 ten times and got into settings. X was 1000111, Y and Z were 0000111. I...
  • F
    Froneck reacted to CarbideTip's post in the thread Analam Wizard help with Like Like.
    Hi there. I think I have a copy of the right manual for this readout. Here's a copy of the 'settings' page: My lathe came with the...
Top