Largest Manufacturing Technology Community on the Web
Stay Connected:
gkoenig's latest activity
-
gkoenig reacted to Vancbiker's post in the thread New Haas UMC 350 Models Coming Out Soon with
Like.
Did the Swissmak joker get a job at Haas????? -
gkoenig replied to the thread BT30 pullstuds.It wasn't done locally - the PVD supplier is back east and mostly deals in quite large volumes. This was a run of about 200 holders and...
-
gkoenig replied to the thread BT30 pullstuds.You send the Brother holders out to a shop that will PVD coat them Speedio Blue, so you never mix them between machines...
-
Hahahaha...Playing devils advocate 🤭, if that's an off the shelf TRT100 rotary, then I guess the machine is cheap to rebuild when...
-
Pick the machine up with a crane, slide a Mikron into place... Boom, accurized Haas.
-
gkoenig replied to the thread New Haas UMC 350 Models Coming Out Soon.Incredible!
-
hold up... they're actually just bolting on a TRT100 on this bitch? LMFAOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO...
-
gkoenig replied to the thread New Haas UMC 350 Models Coming Out Soon.My mistake! I had a Lang bolted onto my model and started thinking it was a 400mm platter. In the end, it is going to be a heck of a...
-
gkoenig replied to the thread New Haas UMC 350 Models Coming Out Soon.It is the same set of challenges you have with a robot. You can do flip stations, creative transfers with spindle orientation, etc etc...
-
gkoenig replied to the thread New Haas UMC 350 Models Coming Out Soon.Couple of reasons: 1- I can get more parts in the machine and a higher walkaway time. 2- *Good* pallets are expensive in both...
-
gkoenig replied to the thread New Haas UMC 350 Models Coming Out Soon.Schunk and PHD both make adaptors with shanks to put their standard pneumatic gripper modules in a tool holder, and actuate them with...
-
gkoenig replied to the thread New Haas UMC 350 Models Coming Out Soon.Not ideal, but everything is a set of trade-offs… and the above package is proven in enough shops that the B Axis centerline issues are...
-
gkoenig replied to the thread New Haas UMC 350 Models Coming Out Soon.And for the price of a KSP Vise and a $1000 spindle gripper from Schunk, that S700 with the TNT100 can run hours of unattended...
-
gkoenig replied to the thread New Haas UMC 350 Models Coming Out Soon.That configuration makes very little sense to me. So you get a 100mm platter... and nothing more. That seems like very small table...
-
gkoenig replied to the thread Japanese Machines made in Japan?.I didn't know those existed until I saw one in a shop a couple of weeks ago, and I was impressed! How do you like yours?