give Kieth Davis a call at 770 560 7996 and have him demo Opticam for you.Way cheaper that Esprit, and easy to use. You'llbe spittng out ready to run programs in a day or two!
You really should contact Keith Davis about Ficus! You'll never look back! He'll comeout and demo it on your parts and your equipment. Call him at 770 560 7996 The software is fast and easy to use and Keith gives great support.
ficus metalcam is the best wedm program going! really fast to program, my system never needs edits to run perfectly! Talk to Kieth and tell him Gregg sent ya!
for your wire, Opticam is un-beatable! I think it started out as Metal cam, now it's opticam or Ficus. Outputs programs for our Sodick VL600Q that do not need editing, just run them!
I have the same equipment as you! Idraw up my 4 axis parts in Solidworks and program them in OneCNC, which does a really great job, and is easy to use? You basically "unwrap" the part to flat and program it as such after telling OneCNC that is your intent. The simulation runs in 3d, really nice...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.