1131 is the code for mazak on the correct page but you can get yourself into a bad spot if you just start changing things id make sure you have the machine parameter list
I have recently changed out in control on our M32B VTC-16 mill and the parameters were taken from a different VTC-16 but there were no information to set the deceleration on the ATC and it is slamming at the end of each change and dropping tools a parameter list or the bits for the tool changer...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.