Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
kenscabs's latest activity
-
Kkenscabs posted the thread BP elevating shaft pinion gear not going in far enough. in Bridgeport / Hardinge and USA Light Iron.This shouldn't be so hard to figure out. Pulled everything apart only replaced the 2 bearings, part #91, replaced with the exact same...
-
-
Kkenscabs replied to the thread BP Knee Elevating Bearing position.The question is when you replace them do they have a thrust direction or doesn't it matter.
-
Kkenscabs posted the thread BP Knee Elevating Bearing position in Bridgeport / Hardinge and USA Light Iron.I did a full tear down and after pulling the shields off and cleaning/regreasing bearing 79 I noticed there's no indication of a thrust...
-
-
Kkenscabs replied to the thread OT: Dishwasher recommendation.Another Bosch here going on 15 years+. If it wasn't for the red light shinning down on the floor you'd never know it's on.
-
Kkenscabs replied to the thread Best Belt grinder belts for steel?.60 is the general grit on my 4x72. 80 would be finishing. I wouldn't waste my time with a 100.
-
Kkenscabs replied to the thread FS: 5/8” shank SNMG and Manchester grooving/ threading holders and 1” shank T&O Flexmill.I'll take both turning tools.
