What's new

Recent content by Mien23

  1. M

    Mits FX10 WEDM Corner pickup

    Sorry If there is a misunderstanding. The Mits. FX10 has a built-in routine to pick up a corner. But in both cases (start hole in the block or start point outside of the block ) the machine has a wire cut just before it moves to it stat location.
  2. M

    Mits FX10 WEDM Corner pickup

    Ok Yes Im New to wire EDM...LOL I have a Mits FX10 . So when you do an outside corner pickup and the start point is outside of the block, Why does the machine cut the wire before it moves to the start point? Can we remove the wire cut? Mien23
  3. M

    Y02 system error

    Slowly its getting better every day...... Started to cut on this Mitsubishi FX10 Wire EDM , But now Im getting a Y02 System error. The book tells me its a amplifier connector and or power source. Can anyone tell me the what the Amplifier board looks like? Mien23
  4. M

    Collision program

    The Collision maps out the table so it will not crash. Its like the DOSA program to reset the sill plate. Mien23
  5. M

    Collision program

    here is a photo of the screen if this helps
  6. M

    Collision program

    Hi all Got a simple question That seem to have stump me. I have a FX10, Yes Im new to wire EDM's. I'm trying to run the "collisn.nc" but it alarms out "P232 no program No". ? How do I set the program number? Mien23
  7. M

    Mits FX10 WEDM Water Problem

    do you know what Solenoid controls this? and thanks for the reply.
  8. M

    Mits FX10 WEDM Water Problem

    Hello everyone. Sorry yes i am new with this wire machine. I checked the water pump direction and it is turning correctly. But i am getting a water spray coming out the back of the machine were the chopper is . Can anyone tell me why this might be happening? Mien23
  9. M

    Mits FX10 WEDM

    Update thanks to Mr Crespo I did check the lower servo board connections. There are two sets of screws , one for the black wires and the lower set for the Red and white wire. Once connected to the right place the machine now turns on and I have movement on the tables. Neil:)
  10. M

    Mits FX10 WEDM

    Hey Dave start a new tread and you might more peeps looking at your problem.
  11. M

    Mits FX10 WEDM

    Thanks you Mr Crespo . the wires are label X,Y,and Z . but the strip on the machine is label L ,M and S. are these the wire you are talking about? Mien23
  12. M

    Mits FX10 WEDM

    here is the connection
  13. M

    Mits FX10 WEDM

    Hi Everyone We bought a Wire EDM and look at it before we bought it. No alarm and the table moved nicely. Now we have it at the shop and powered up. We changed the two batteries and reloaded the disks, all seem to be going ok until it booted up. Servo alarm S03 NR 46 X . I can not seem to be...
Top