Largest Manufacturing Technology Community on the Web
Stay Connected:
ncjeeper's latest activity
-
I've acquired a Lehmann Hydrareol 18 x 96 lathe. We pulled it out of a R&D shop and it's just bigger than I need. Comes with 3 jaw and 4... -
ncjeeper replied to the thread What psi concrete is the typical warehouse / factory floor?.I went with 6 inch and 4000psi mix for my shop slab. We dug down an additional 4 inches (for a total of 10) in the area where my future...
-
ncjeeper replied to the thread Ex-Cell-O 602.Is that the original paint color? If so it looks pretty good. Mine was painted black when I got it, ugh. I went back with machinery gray.
-
ncjeeper replied to the thread Looking to buy Trav A Dials.I have one. I bought it a while back to put on my big lathe. I never installed it and I just use DTI's. It seems to work but I can't a...
-
-
ncjeeper replied to the thread Ex-Cell-O 602.My Excello 602 has been a good machine. I do need to replace the spindle bearings at some point.
-
ncjeeper reacted to dalmatiangirl61's post in the thread Found in 1840s farm house basement - stone weight driven pump? with
Like.
Acetylene gas generator, the gas was used for home lighting, I've only seen a few, they looked similar, so that is my wag. -
ncjeeper replied to the thread Almost had a new B&S horizontal mill.Did you file a complaint with the attorney general?
-
ncjeeper replied to the thread NOS Moore 1-2-3 block set. Still wrapped. Sharing and question.Same here. They would get used.
-
ncjeeper reacted to sfriedberg's post in the thread NOS Moore 1-2-3 block set. Still wrapped. Sharing and question with Like.
If I were to buy it, I would use it. So right in the category MB Naegle describes.
-
ncjeeper replied to the thread Scrap Price Crashing?.I have not checked lately. But from you guys are saying I wouldn't even make enough to pay the gas to drive the scrap there.
-
ncjeeper replied to the thread 20" G&E Shaper - Unloading and eventual power up.I am envious of the auto down feed. I wish mine had it.
-
ncjeeper reacted to tx656's post in the thread 20" G&E Shaper - Unloading and eventual power up with Like.
This a link to the post where this machine originally was noted on PM...
-
ncjeeper replied to the thread Brown and Sharpe Omniversal - brought one home.Oh man that is cool. Nice purchase.
-
ncjeeper replied to the thread Gould and Eberhardt 14” tool Room Shaper for Sale.The Universal model came with the rotating table and tilting top I believe.
-
ncjeeper replied to the thread The Rare Monarch Machine Tool Surface Grinder.Never knew that. Thanks for the photos.
