What's new

Recent content by Nust

  1. N

    Advice On 3 Phase Power Options For My First Mill

    Hi Rons, It was one of the Huanyang units. It did initially toss an error code. I hit stop and went to get my manual to reference the code. I made the mistake of assuming the exact same issue would occur when I hit start again. Sadly it did not, instead this time it let out a rather...
  2. N

    Advice On 3 Phase Power Options For My First Mill

    Thanks Thermite, I'll track down a suitable motor, have you got a source for assembling the remainder of the RPC? Again electrical Isn't my strong suit so I will definitely need some info on the assembly. I appreciate the info. Jim, I'm looking to see where my error was, the wiring looks...
  3. N

    Advice On 3 Phase Power Options For My First Mill

    Yes just a small motor, 1.5hp motor. I'd prefer not to blow up anything else if avoidable... I have a basic offshore VFD that is setup on my Harrison lathe with some electrical help from a friend. I'll do some looking at RPC options, not sure how easily I can find another motor for an idler...
  4. N

    Advice On 3 Phase Power Options For My First Mill

    Hi Everyone, I have an Excello 602 that I recently picked up as my first Mill. The unit is built for 220/440 3 phase power. My workspace is just a home shop with only single phase power. I tried one of those VFD's by a name we shall not speak and clearly made an error and its no longer with...
Top