Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Rickyb's latest activity
-
R1095 in spring temper is easily machinable with carbide ,and can be drilled and sawed with HSS tooling at low speed....Silicon steel is...
-
RRickyb reacted to goldenfab's post in the thread Request for Help with Custom Lathe Headstock with
Like.
Given your setup 20 thou of deflection isn't surprising. The second setup looks better except for the part where its mounted to wood... -
RRickyb reacted to MikeBurgess's post in the thread Request for Help with Custom Lathe Headstock with Like.
.5mm deflection under what load and in relation to what? You have several slip connections and low precision bearings all mounted on a...
-
RRickyb replied to the thread OT..OSHA Scaffold.Certificates and certification are fine but…did you think about people in the area it may upset. They might get scared by how tall it...
-
-
RRickyb replied to the thread Can this precision level be calibrated?.Yes and for a precision level it’s easier sad than done. Like measuring 1/10ths. Measure, remeasure and then one more time to be sure.
-
RRickyb replied to the thread How to store the energy from the nanopores.It does have that fishy smell. The smell of fishing for more grant money.. However, we will likely get more from these $$ than...
-
RRickyb replied to the thread Can this precision level be calibrated?.Not necessary. Op has the right idea, levels can check themselves.
-
RRickyb replied to the thread Tie rod end measurments almost correct.I think we are on the same page just a different paragraph. Grabbing a junk steer axle for me raises a red flag that the Ackerman...
-
RRickyb replied to the thread Tie rod end measurments almost correct.Can’t say for sure, but yes most likely.
-
RRickyb replied to the thread Tie rod end measurments almost correct.Dooz, I’m very impressed. Amazed at what you did. Audel has a great series of books. I have a few.
-
RRickyb replied to the thread Tie rod end measurments almost correct.You are 100% correct but 100% off the mark. I was not talking about cars or about driving straight down the road where Ackerman has...
-
RRickyb replied to the thread Tie rod end measurments almost correct.Only thing not to great was that every part was a saftey related component with special everything requirements. Failure of any...
-
RRickyb replied to the thread Tie rod end measurments almost correct.2.5 ton are the little guys. Big boys are 6, 6.5 and 9 ton.
-
RRickyb replied to the thread Tie rod end measurments almost correct.As I originally read this post I was thinking you we just mixing the terms calling a drag link ball socket a tie rod end. Reading this...
-
RRickyb replied to the thread Tie rod end measurments almost correct.It’s the steering ball/ drag link taper. Tie rod taper is in the tie rod arm. Freightliner started making their own axles sometime in...
