rmsfla

Hi Robbie,
Do you still have the Cincinnati change gears with crank handle and drive shaft?

Regards
Josh

Hey do you still have the cam lock arbors end mill holders? I've been looking everywhere for them

I had not been on this site for a long time...
Like to help..Do you still need that part tapped?
My email
themachinist at bellsouth dot net

Robbie,
I'm new here and I don't know if i allowed pm's,my e-mail is [email protected]

I noticed in the thread about making an acme tap that you have an acme tap bank.
I need a 1/2-8 LH cut in a 7/8"dia X 2"long pc of 660 bronze.
is this a size you have? and $$ to run a tap through the part?
Thanks,
bill