I don't want to change it every time. I want to change the parameter that is responsible for the value Q. So that each next worker can safely make a post and not change anything.
Hello to everyone Maybe someone know how to change tolerance pushing check (Q) in transfer, in caps?
For example:
G38 B-44. K.01 F30. Q1.
By default it is 1 mm.
mori seiki nzx 2000.
In program #5 there is a condition if it takes place only then you will need to go to program #6 if not just finish and return to the previous program #4
How to call sub program from main mazatrol program to sub iso program and after that to sub program mazatrol (not main program)
For example:
#4 (mazatrol main program) call to
>#5 (sub program iso) call to
>#6 (mazatrol not main program)
This works but not correct . After calling...
Hello people. I tried go from mazatrol to iso then from iso to mazatrol else. (Lathe Mazatrol fusion 640m) how i can do this?
This is what i was going through:
this sub program is in the main program:
#150=#150-1.
IF [#150 EQ 0.] GOTO 10
M99
N 10
M198P6
M99
if the #150 is zero, this sub...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.