Largest Manufacturing Technology Community on the Web
Stay Connected:
Safarir's latest activity
-
SHi All, I recently squired a Brown & Sharper Micromaster 510 that seem to have most of the guard in place to run flood coolant but it...
-
-
SSafarir replied to the thread Micromaster 510 Surface Finish and Vibration.Today I had the chance to play a bit with the grinder. The first task was grinding the chuck That first attempt was pretty bad but the...
-
-
SSafarir replied to the thread Micromaster 510 Surface Finish and Vibration.I used this bearing vibration calculator for 6203 bearing and there is no match for the 190hz. Brandenberger message inspired me to...
-
-
SSafarir replied to the thread Micromaster 510 Surface Finish and Vibration.Phase Perfect
-
SSafarir replied to the thread Micromaster 510 Surface Finish and Vibration.I will definitively take the time to read this, it sound really interesting ! So I went ahead and drilled some holes in the pulley to...
-
-
SSafarir reacted to metalmagpie's post in the thread Micromaster 510 Surface Finish and Vibration with
Like.
Good for you on learning about balancing and sharing your knowledge. When faced with a wavy finish, the first thing to check is the... -
SSafarir replied to the thread Micromaster 510 Surface Finish and Vibration.I finally had time to make more progress: The motor was re-assembled with some new bearing, it now sound way better Here is the...
-
-
SSafarir replied to the thread Micromaster 510 Surface Finish and Vibration.This is awesome! What are those sensor you are using ?
-
SSafarir replied to the thread Micromaster 510 Surface Finish and Vibration.Hi Conrad, Yes, I saw your page, this was my main inspiration on how to balance the wheel. Thank you for this amazing write up ! My...
-
-
SSafarir replied to the thread Micromaster 510 Surface Finish and Vibration.I went ahead and remove the motor. Running it by itself, I was not happy the amount of vibration coming out of it and the noise it was...
-
-
SSafarir reacted to michiganbuck's post in the thread Micromaster 510 Surface Finish and Vibration with Like.
Thanks for sharing your testing. As fast as you can hand crank long travel and as slow with taking a light cut should be OK. You should...
-
SSafarir replied to the thread Micromaster 510 Surface Finish and Vibration.It is hard to say exactly how fast I am running the table. The best I can say is: about what seem average from the youtube videos I...
-
SHi all, I recently got my hand on my first surface grinder, a Brown & Sharp 510. After doing some initial testing, I was really unhappy...
-
-
SSafarir replied to the thread For Sale ! ! !.I have a Wohlhaupter UPA3 Mo.4xS20x2 boring head which I think might fit a Deckel. Located in Ottawa, Ontario, Canada, will ship...
-
