Hi, Tasmor!
Sorry for the slow service, I've been abroad.
No, no such luck. I had the pics uploadet to an ISP I since left. I remember that I managed to mount the x scale under the table directly below the x endstops, the Y and Z were on the left side. I made an aluminium bracket for the Z scale reading head, mounted with the screws normally holding the shelf for x- axis gauge blocks. Hope this is of any help!
Ole
Sorry for the slow service, I've been abroad.
No, no such luck. I had the pics uploadet to an ISP I since left. I remember that I managed to mount the x scale under the table directly below the x endstops, the Y and Z were on the left side. I made an aluminium bracket for the Z scale reading head, mounted with the screws normally holding the shelf for x- axis gauge blocks. Hope this is of any help!
Ole