Since I am trying to almost give the NMTB50 away im not going to put up with a lot of crap. I have Mill Holders, Erickson type 150 collets. Large end mills, etc. If one of you want to send me an email I will respond in kind. If you are not interested I will throw them in the scrap. If you are...
I have a fork lift for sale on craigs list and I received this offer. I looked him up on the internet and he has been doing this for awile.
Sent by Jery Watts on a fork lift I'm selling.
Thanks for the prompt response,i will like to proceed with the
transaction asap and my mode of payment...
Steelz:
After you loosen the big nut. Romove the two haves. Turn the tool end for end and reinsert the tool and see if it will turn the smaller adjusting nut. By tighting this nut this should remove the backlash. Don't over do it or you will not be able to turn the crank.
Hope this helps.
Bill C.
Longitudinal Sdrew Backlash Adjustment
steelz:
What is difference between the 1-1/2 TMV and the RT2S or RT2V table ? I have had two the these mills and the adjusting nut is on the left hand side looking under the table. My manual indicates that you
1. Move the work table to center of the...
I know that a lot of people on this forum want to use Paypal to pay for the items they purchase here. I just sold some items for $90 and Paypal charged me 4.567 % on the transaction. Since I shipped this item for the person on this forum the total amount for items and shipping was sent to my...
I have several of these end mills that are all 2" dia. and 2 flute. I have no idea what they are worth but I cannot use them.
#1
Fastcut (usa)
Acculead 10.833
2.000 M7 82353
30C33033
E2045-00
OAL 7.75"
Cutter length 4.50"
#2
Brubaker
2" HSS
8-e
OAL 7.75"
Cutter length 4.125"
#3
Morse (usa)
2"...
15mules
The most common Bridgeports have a X axis 42 inch table. I think you will actually have a 30 inch travel maximum on the 42. The 48 inch will give you a sight bit more however I dought you will really need it. The 32 inch table is a little short but fits nicely in a small shop. It is not...
I had an production engineer hand me a drawing of a case packer part on a napkin with the tollerances of (-) .000 (+) .0001. I just made the part out of 304 SS and gave it to him. He said it worked great. The part replaced an aluminum bracket and I know I'm not capable of the tollerances he...
Please send me an email and I will get you pictures and descriptions. Probably $15 each without endmill and $20 with end mill. They are in real good shape.
Bill Clarke
[email protected]
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.