What's new

Recent content by upnorth

  1. U

    Thinking of going with EZ-CAM for software..?

    I had the ezmill express package and did not care for it one bit. Ask Chris at ezcam about a full unlocked trial period. If he wants to sell he can do it for you. Don't let him give you the scenario of what you are trying to do with it. I had for some simple 3d cutting and it wouldn't do it, so...
  2. U

    F/S Kurt D 688

    I am not going to take the vise. Shipping would be way to much. It is all yours. U.P. North
  3. U

    F/S Kurt D 688

    You have a private message.
  4. U

    FS: Used & NIB 5C Collet Lots

    Just sent you a private message.
  5. U

    FS: Used & NIB 5C Collet Lots

    Are the collets internally threaded?
  6. U

    hey Mike , Tim here from Ironwood. Long time no talk. What have you been up to? Got rid of my...

    hey Mike , Tim here from Ironwood. Long time no talk. What have you been up to? Got rid of my cell number when i lost my phone, as the contract was up on it. So I lost your phone number. Email me your number ([email protected]) and I will give you a call.
  7. U

    fs pair of 12x36 magnets

    magnets picked grinder and magnet up from mike what a swell guy to talk to. he sure went the extra mile for me meeting me a few hours before he had to go to work. machine and magnet were just as described. the magnets he has listed are in beautiful condition (like new). this guy is a+ in my...
  8. U

    fs pair of 12x36 magnets

    mike, will see you early in the a.m. . will call you when i get near houghton. have to go bed now have to get up way to early . thanks, tim
  9. U

    fs pair of 12x36 magnets

    mike, that is good news on the magnet (6x12). is it a fine pole or not.and is it permanent or d.c. powered. you say you will throw in the grinder it is on. what kind of grinder is it. i am located only 120 miles from you. Please get back to me a.s.a.p. as i am in desperate need for a magnet as...
  10. U

    fs pair of 12x36 magnets

    mike, you say you dont have the controls for these. what kind of shape are they in and where are you located. also wondering if you would have any other magnets. more in the size of 6" x 12"? thanks, u.p. north (tim)
  11. U

    Hendey Lathe (help please hendyman)

    Would like to know the info on this lathe. A friend of mine has it. Is a 14x6 conehead tie bar the serial number is 27487 . thank you in advance, tim
  12. U

    rfq for keyways

    RFQ Closed Thank you all for your time , this job has been awarded.
  13. U

    rfq for keyways

    update on groove sorry guys this was misstated as being a keyway. it is a welding groove as you can tell by the width tolerance it is not really critical. thanks, upnorth
  14. U

    1.500 O.D. touch top of part with cutter zero it and move table up or cutter down .750 and that...

    1.500 O.D. touch top of part with cutter zero it and move table up or cutter down .750 and that should give you .750 left to be measured. i have enough tolerance in the mating parts so it will work if the shaft distorts. This gets welded to another part as i am sure it will move a little. This...
  15. U

    rfq for keyways

    O.D. tolerances are 1.500 - 1.495 these are a prototype so changes could come in the future
Top