Largest Manufacturing Technology Community on the Web
Stay Connected:
Recent content by williamsbrown
-
W
EZ Trak Spindle Start problem
Yes, E-stop does work and I can engage the spindle forward or reverse using the switch to select up front and the magnetic switches from inside the main cabinet, pictured above.- williamsbrown
- Post #8
- Forum: CNC Machining
-
W
EZ Trak Spindle Start problem
No, it is a southwest Industries out of Las Angeles. Usually quite reliable, the Hardinge models from the early 2000's were pretty awful, they were EZ Vision controls.- williamsbrown
- Post #7
- Forum: CNC Machining
-
W
EZ Trak Spindle Start problem
Thanks, I did some investigation of the bijurr oiler and found that I have 120 on two legs as is proper and white on the terminal marked N (presumably for neutral) The motor inside got warm like I would expect but I do not no where to check for the interlock I've also discovered that by...- williamsbrown
- Post #3
- Forum: CNC Machining
-
W
EZ Trak Spindle Start problem
I have an EZTRAK mill 2 HP model circa 2000 that I recently installed in my garage. Everything works except when pushing the spindle on buttton I get nothing.:nutter: Have bumped the spindle by pushing on the relay in the control panel but am unable to turn on by normal means. I installed a...- williamsbrown
- Thread
- Replies: 9
- Forum: CNC Machining
-
W
Need some help with a new to me Bridgeport Ez-Trak sx
EZ Trak Spindle Problems I have an EZTRAK circa 2001 that I have been working to install in my garage. I have been a machinist both manual and CNC for my entire career and look forward to some quality hobby time on it. I have installed a phase converter and have everything working but the...- williamsbrown
- Post #28
- Forum: Bridgeport / Hardinge and USA Light Iron