I believe this is for the 16 or 24" lathes. The clamp and some of the hardware are shopmade - I don't have a lathe of this size to test the fit, but I think I'm pretty close on the clamping parts; some minor adjustment may be necessary.
There was a fair amount of rust when I got this, the aftermath of which can be seen on one end of the stop rod. I cleaned up the end of the rod on the lathe, but this resulted in a loss of about 0.050 length and the loss of the heat treated portion.
Also, in the pics, you can see some slight breakout in the casting where the hold down screw recess is, doesn't affect function and doesn't extend down past the bottom of the counterbore. Been completely disassembled, cleaned and oiled, works smoothly.
Click on the pics for clearer versions, if you need dimensions, just ask away.
$85 includes shipping to lower 48
There was a fair amount of rust when I got this, the aftermath of which can be seen on one end of the stop rod. I cleaned up the end of the rod on the lathe, but this resulted in a loss of about 0.050 length and the loss of the heat treated portion.
Also, in the pics, you can see some slight breakout in the casting where the hold down screw recess is, doesn't affect function and doesn't extend down past the bottom of the counterbore. Been completely disassembled, cleaned and oiled, works smoothly.
Click on the pics for clearer versions, if you need dimensions, just ask away.
$85 includes shipping to lower 48