dalmatiangirl61
Diamond
- Joined
- Jan 31, 2011
- Location
- BFE Nevada/San Marcos Tx
Its been 24+ hours, what worked?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
I hear hexagons are also a nice shapeI will not know for a week or more. I am moving and I found my smaller hole saws and arbors. I think I have a hole saw of the correct diameter but I have to find it. I will see if I can buy a narrow blade for my oscilating cutter to make short chord cuts to form a circle.
Bill D
I have used pipes with a sharp inside surface bevel. The pipe section is chucked into a drill press.To go under I need to cut two six inch diameter holes for the lathe feet pads. I was thinking hole saw or jig saw. Mat is too big and heavy to use a flycutter in the drillpress.
Grind a piece of 6 inch pipe and pound it thru the MattI have used pipes with a sharp inside surface bevel. The pipe section is chucked into a drill press.
At medium speed it passes straight thru with nice smooth surface finish.
On your job I would buy a 6" galvanized pipe nipple 1-2 inches long and a end cap.
Remove the thread on one side of the nipple and sharpen the inside edge.
Drill a hole in the center of the cap and weld or bolt on a 1/2" bar about 6" long.
Screw on the cap. Chuck end of bar in drill press. Now you can go through some rubber
Use a plywood base underneath the rubber mat when making the cut.
Matt would report you to the Poooolice... But Mat would not.Grind a piece of 6 inch pipe and pound it thru the Matt
Don
Notice
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.