Largest Manufacturing Technology Community on the Web
Stay Connected:
Search results
-
N
Smart & Brown 1024 Vsl, Help needed.
Hello everyone, I was using my Smart & Brown 1024VSL this evening everything was working well but my increase and decrease buttons for spindle rpm would not work,spindle was spinning just no rpm control. I could hear it trying to engage/increase. Has anyone ever had this problem? Any ideas... -
N
Smart & Brown 1024 VSL
Very good points Termite, I would probably do a you said if I got the RPC, I'll have to look into what one I should get to run it and as you say be getting all the bits together to go down the route of VFD conversion- Ntgar
- Post #10
- Forum: Transformers, Phase Converters and VFD
-
N
Smart & Brown 1024 VSL
Hello Billmac, Thank you for the detailed reply, I have been reading through old posts on PM and seen you had used a VFD,(I Was The one who left you the Visitor msg in your profile page) I would really appreciate a copy of your write up and drawing, I know they are different models but even...- Ntgar
- Post #8
- Forum: Transformers, Phase Converters and VFD
-
N
Smart & Brown 1024 VSL
Thank you very much for the reply, yeah PM has been great, I just posted the question as I had gotten so much info I wasn't sure what route to take, thanks very much again for the help- Ntgar
- Post #3
- Forum: Transformers, Phase Converters and VFD
-
N
Smart & Brown 1024 VSL
Hello everyone, Im just looking for some advice, I have been offered to buy a Smart & Brown 1024 VSL in very good conditionand the question I have is my workshop only has domestic electricity so is it possible for me to run a converter to run the Lathe as I would really like to get it, any...- Ntgar
- Thread
- Replies: 13
- Forum: Transformers, Phase Converters and VFD
-
N
Smart & Brown 1024 VSL,
Hello everyone, Im just looking for some advice, I have been offered to buy a Smart & Brown 1024 VSL in very good conditionand the question I have is my workshop only has domestic electricity so is it possible for me to run a converter to run the Lathe as I would really like to get it, any... -
N
Hello Billmac, I have been reading posts on the site about Smart and Brown 1024 lathes, I...
Hello Billmac, I have been reading posts on the site about Smart and Brown 1024 lathes, I hope you don't mind me messaging you but I have just bought a S&B 1024 VSL and I read on one of the pages you say.... "My 1024 has a VFD and I can select either the same speed change method as the...- Ntgar
- Profile post