Largest Manufacturing Technology Community on the Web
Stay Connected:
Search results
-
W
Help With Baileigh Press Brake.
This has been fixed.After turning the x axis back on,apparently it needed a value (not necessarily the correct one) for it’s location.After putting an arbitrary number in,it “found” where it was.- watch this
- Post #2
- Forum: Baileigh [Sponsored Forum]
-
W
Help With Baileigh Press Brake.
We Purchased a 50 Ton Press Brake (Model BP5078CNC according to Baileigh's web site,Model PPTK 40/20 according to the Plate on the machine)with the YSD 3000d controls.The questions/help I need with it are as follows: 1.When in manual mode,if I jog the "x" axis (backstop),it PHYSICALLY moves...- watch this
- Thread
- Replies: 3
- Forum: Baileigh [Sponsored Forum]
-
W
Die sensor question.....
These are small to mid sized stamping dies.(15-200 tons).- watch this
- Post #7
- Forum: General
-
W
Die sensor question.....
Looking for a "no thinking/skill" required solution to this.The stop blocks are 2" dia.already.I understand bigger block would be more surface area for the impact.- watch this
- Post #4
- Forum: General
-
W
Die sensor question.....
Anyone have any luck using sensors in the stop blocks to keep moronic setup guys from setting the die too deep?Evidently using solder is too much of a burden to use.I see it being more of a hassle on my end because once the stop gets an imprint in the punch holder,it(the sensor)needs to be...- watch this
- Thread
- Replies: 7
- Forum: General