Largest Manufacturing Technology Community on the Web
Stay Connected:
Search results
-
K
HI Billmac This is Terry from Malta Europe. I was reading your post at deckel/maho machine. and...
HI Billmac This is Terry from Malta Europe. I was reading your post at deckel/maho machine. and i found it a lot interesting, (seems your an expert on such machines). I own Maho Mh 800(manual) milling machine. I baught it about two months ago and i worked only few hours with it. I have problems...- kapsa
- Profile post
-
K
Pump Recommendations, Need Suction and Self Priming
worked in sewage treatment plant. Every pump is submersable, they all work at low cost and very few maintance. you just need to make the raising main fixed to the wall and when you need to get up your pump just get up only the pump with a small chain block will do. Hope will help a bit -
K
Pump Recommendations, Need Suction and Self Priming
the most easiest way is to use submersable pumps for sewage. at least that what i think from my expirience. And you dont need a big pump though you dont have a lot overhead pressure. -
K
Maho MH800
hi Ross. Thanks for the information. till now i didnt found any way yet. but now i must check wiring as you said. thanks ross if i will have any news i will inform you.- kapsa
- Post #6
- Forum: Deckel, Maho, Aciera, Abene Mills
-
K
Maho MH800
Hello Peter thanks for ansuering me back. Thats why i make this question on this forum to try to get some help. because it is very dificult to work directly switching on and off the feed motor. i wish to know if i can engage or disangage when the powerfeed motor is still working.- kapsa
- Post #4
- Forum: Deckel, Maho, Aciera, Abene Mills
-
K
Maho MH800
is it possible that no one owns an mh800 out there. thanks- kapsa
- Post #2
- Forum: Deckel, Maho, Aciera, Abene Mills
-
K
Maho MH800
HI guys. i just baught a maho mh800 milling machine. and i found some problems to work the power feed, as i could not find any clutch. my power feed need to be engaged before starting the power feed motor otherwise canot work. i wish to know if this is normal about this machine. this is the...- kapsa
- Thread
- Replies: 5
- Forum: Deckel, Maho, Aciera, Abene Mills