Largest Manufacturing Technology Community on the Web
Stay Connected:
Search results
-
N
Micro Machining Titanium
Correct I had some small 0.02" radius corners that I needed to clean up. I was getting some burr like finish on the z level as well which is why I had the .055 and 1/8" leave .002" for the .035" end mill to clean up. I've reduced that now and I think that will help but still going to check...- nmercier
- Post #6
- Forum: CNC Machining
-
N
Micro Machining Titanium
I was using a 3 FL Harvey End Mill and was running 75 SFM @ 8000 RPM. Feed per tooth was .00006 with 1.5 ipm. Got all the numbers from Harvey and lowered the SFM to be conservative. Going to start with checking runout and re-evaluating the toolpath.- nmercier
- Post #4
- Forum: CNC Machining
-
N
Micro Machining Titanium
Hey Guys, Looking for some tips and tricks for machining Titanium. Kind of a rough setup as I'm running a 2003 HAAS VF2 SS and milling a piece that is smaller than an inch in X,Y, and Z. I've gotten good results on most of my end mills but I keep snapping a 0.035" Diameter End Mill as I'm...- nmercier
- Thread
- Replies: 5
- Forum: CNC Machining