What's new

Search results

  1. D

    Lathe Controls - FAGOR 8055

    Hi Everyone, This community was very helpful with my trouble shooting on the milling side using FAGOR 8055 controls so I thought I would ask for the lathe side of things as well. So same scenario, I am programming using fusion 360 and I testing to make sure my machine post is working...
  2. D

    FAGOR 8055 Help!

    UPDATE! I gave a few attempts so I am going to walk through what I did and what the results were for each attempt. 1. I added a G17 to line N135 before G0. When I ran the simulation I got another error but at this time at N175 with a Z axis soft limit overrun. 2. So then I added a G17 in...
  3. D

    FAGOR 8055 Help!

    Hi Bill, I understand the concept of G17,G18,G19, but I am just wondering why my machine post would change which one to call out when the tool is to follow the same path? Only thing that I see changing is the Z value. But I do think you are on to something here with those codes because it...
  4. D

    FAGOR 8055 Help!

    Ok so here is what I found. In the Error Manual it states that I programmed a path out outside the defined limits by the axis parameters LIMIT+(P5) and LIMIT-(P^). In the installation manual it says that the default limits to these are P5=8000mm and P6=-8000mm, so I will see what the machine...
  5. D

    FAGOR 8055 Help!

    Hi Everyone, I am trying to run a program from which I had created in Fusion 360 and posting it out to run on a 3 axis mill using FAGOR 8055 control. I going to give all info in detail with what I am seeing and doing and maybe someone has run into a similar situation here. - I upload my...
Back
Top