What's new

Search results

  1. S

    AXYZ Canned cycles ignore material offset

    HI, Thanks for taking the time to read my post. I'm running an AXYZ 4008, using Fusion 360 as my CAM software, and using the generic AXYZ post processor that Fusion provides. I've encountered a weird problem. The AXYZ controller sets it's G54 datum as the top of the spoil board then you can...
  2. S

    How do I turn parts that don't clear the cross-slide?

    Hello All, Thanks for taking the time to reply, really appreciate your advice! I'm going to to give the left-handed boring bar a try. I might be able to get away without sticking it out the full 200mm because I'm turning a taper on the OD. Once I've roughed down the front a bit I may be able...
  3. S

    How do I turn parts that don't clear the cross-slide?

    Hi, Thanks for taking the time to read my post. I am relatively new to machining and have a problem to which I hope there's a simple answer. I am trying to turn a part on my lathe (HAAS TL-2). This is a large part (~400mm diameter). It clears the bed no problem, but it doesn't clear the...
Back
Top