What's new

Search results

  1. P

    Any recomadations on a roughness surface tester?

    {spam deleted - ref http://www.practicalmachinist.com/vb/metrology/forum-policies-re-copyrighted-material-spam-241690-post1758513/#post1758513 - TRL}
  2. P

    Hi Chris999, Reading a post about the mahr maxum indicators and I am having the same issue, no...

    Hi Chris999, Reading a post about the mahr maxum indicators and I am having the same issue, no instructions on how to use them. Any chance you could email me a copy of an instruction manual for the Mahr Maxum III? Sure would appreciate it. [email protected]
  3. P

    Setting Bore Gages

    2 Canadian cents worth Rockfish, You got it, rings are ideal. Buy new if possible. Overall they are inexpensive (for their longevity)and usable forever without extreme abuse. Buy used for cheap, have them lapped and calibrated. Micrometers are perfect for 2 point bore gauges, but, know the...
  4. P

    gage calibration records

    Gauge software It has been 5 years since I have used gagetrak. It was fine, with all of its potential, but, I would never recommend it unless the boss has seriously mandated accounting of gages(doubtful). If you have a decent knowlege of Excel, or even better; Access, USE THAT. I personally...
  5. P

    Help with Mitutoyo electronic digital micrometer

    Sounds like on the the buttons has a permanent termination. Will have to be taken apart. If you attempt it yourself, 2 CAUTIONS. Be extremely careful not to damage the ribbon cable and use a grounding strap before you touch the circuit board. A reasonable repair can become Expensive fast...
  6. P

    Adjusting a mechanical counter Digital Micrometer

    try sending it to precisiontoolworks.com?
  7. P

    Cleaning Interapid IRA2 Comparator

    what do you mean by timing range? thanks
Back
Top