What's new

Search results

  1. ryan_unmanned

    2004 VF-2SS slowly builds to Error 163

    To follow up on this post for future problem solvers, it took Ellison 7 weeks to come up and eval our VF2. After checking out the electronics in the cabinet, everything was good on that side. Upon pulling the Z Axis way covers, a clip that holds the main lubrication line had snapped off where...
  2. ryan_unmanned

    2004 VF-2SS slowly builds to Error 163

    Apologies, been away from the shop on travel and just had a chance to move some things about, unfortunately nothing positive :( Was: X-axis - 32A (original) Y-axis - 45A (newer) Z-axis - 45A (original) A-axis - 32A (original) TC - 32A (original) To recap, I've already tried switching the A / Z...
  3. ryan_unmanned

    2004 VF-2SS slowly builds to Error 163

    @donkey Proper three phase power HV DC Bus ~322V The largest transformer "source size" is labeled up to 244V-260V, so I would think the machine wouldn't be unhappy at 246V. Thanks for verifying the Z Axis loads aren't unusual! @Stirling Would either of those things occur from moving the...
  4. ryan_unmanned

    2004 VF-2SS slowly builds to Error 163

    Recently purchased a 2004 VF-2SS, was under power (208V) and running prepurchase. I had the seller install a 3.5" to USB upgrade then had the machine shipped about 200 miles to my shop. We had to wait on some panel upgrades, but finally last weekend got 240 run to the machine, switched over both...
  5. ryan_unmanned

    Mazak CAT40 Pull Studs

    9 x Coolant Thru 9 x Non Coolant Thru Would like to sell lot for $125
Back
Top