What's new

Search results

  1. A

    Sl20 how to pause

    Oh, 2006 is when one generation ended I was told. 2006 and older are unsupported. That’s why I bought the 2008 , supposed to have newer electronics that they still support.
  2. A

    Sl20 how to pause

    I believe I have the new generation. One indicator is not having analog meter for spindle current. I’ll look where to turn on top compensation. I like the spread sheet profiler but which you can go back and forth into it with same profile. I’m a mill guy using Cam
  3. A

    Sl20 how to pause

    Working with Sl20 conversational profiler. Does the program take tool tip radius into the program calculations when it generates the g-code Also, appears once you save the profile you can’t go back into the spread sheet part of program. I have to edit g-code by hand. Yes?
  4. A

    Sl20 how to pause

    The virtual conversational you enter x value. I didn’t know if it was asking for radius or diameter. It is diameter
  5. A

    Sl20 how to pause

    It’s diameter for the virtual profile tool. Thanks
  6. A

    Sl20 how to pause

    Next question. My tool is 2008 sl20 In vps haas G71 videos, newer machine, it says enter diameters but I see the code goes to x dimension equal to diameter instead of radius. Do I use radius for my old machine
  7. A

    Sl20 how to pause

    Thank you so much. I’m slowly catching on to this
  8. A

    Sl20 how to pause

    New to SL20 I want to make a face cut on rod and then pause, open chuck and flip part. Then continue This possible? Rob
  9. A

    Sl20 Backside chamfer

    New to this Sl20. Not up to speed with Fusion yet. Is there a way to do a backside chamfer on a part with conversational?
  10. A

    Tailstock alarm

    Thanks much, I’ll give it a try.
  11. A

    Tailstock alarm

    I can’t find it on sl20 Rob
  12. A

    Tailstock alarm

    i’m training myself how to use this sl20 and I’m doing a simple practice drilling operation with the conversational. Simple 1/4” hole. When I hit cycle start it comes up with a tailstock restrictions zones alarm. I have no clue what’s going on. I’m stuck Rob
  13. A

    2008 SL20 spindle motor alarm

    Turns out bad fan. $275, ouch
  14. A

    2008 SL20 spindle motor alarm

    I’m getting a spindle motor heat alarm and the machine is sitting idle. The fan that sits above the motor and below the spindle drive doesn’t turn on sitting idle or when spindle is running. Bad fan? Fuse or breaker some place? Ron
  15. A

    Fusion 360 My machine not in library list

    Thank you
  16. A

    Cam work for hire

    Thanks , unfortunately I’m under non disclosure. Good to know tho
  17. A

    Fusion 360 My machine not in library list

    That’s encouraging
  18. A

    Fusion 360 My machine not in library list

    Yea, putting the word out
  19. A

    Fusion 360 My machine not in library list

    I’ll give it a try . Thanks
  20. A

    Fusion 360 My machine not in library list

    I have live tooling, would I expect the generic post processor to generate the gcode for it also?
Back
Top