What's new

Search results

  1. D

    Haas VF4D Pre-NGC Setting Z Work Offset

    Thank you again for your help post #9 Noted. We are trying to bring in a standard method of work regarding tool length and offsets as you suggest. we are printing tool tags for all our holders as we speak so that we can fill in tool data and the measured offset for each tool and also know what...
  2. D

    Haas VF4D Pre-NGC Setting Z Work Offset

    Thank You DH , yes i worked this out earlier so have turned S64 off now. I have an SPI Tool setter on the table and use Haimer 3d to set the XYZ offsets .
  3. D

    Haas VF4D Pre-NGC Setting Z Work Offset

    Thank you , something so simply. All the controllers i have previously used automatically use the offset assigned to the tool Number. or you put it in the tool selection ie T0303
  4. D

    Haas VF4D Pre-NGC Setting Z Work Offset

    Thank you all for your helpful replies here is what i have done this morning Made sure Setting 64 is on ( it is by Default ) g54 Work Offset set to Z = 0 before i set tool lengths set T2, T3 and T4 to Table with tool offset measure button ( T2 = -18.3260, T3 = -17.3660, T4 = -19.1400) Set G54...
  5. D

    Haas VF4D Pre-NGC Setting Z Work Offset

    Good Evening Everyone , hopefully someone on here can help me out . I Know setting Z Offset has been discussed to death and everyone has different methods and i know this but i need help with how i normally do this I Have inherited a 2001 Pre-NGC Haas VF4 with a workshop i have purchased. the...
Back
Top