What's new

Search results

  1. D

    Tos Trens spindle bearing lubrication

    It's been running for months with no problems. I'm not sure about Kluber or other greases, I am sure they work great. My manual says Mobilux EP 2 is required and that is what I used.
  2. D

    Tos FKN25A Wiring Question

    Indeed, the spindle must be running for the feed switch to operate. It runs like a dream. Thanks!
  3. D

    Tos FKN25A Wiring Question

    Hello, I recently wired up a Tos FNK25A. The table feed lever will rapid in both directions, but in the FEED position, nothing happens. Previous owner says he never had a problem with it. I suspect there is a simple wiring issue. A button on the head shows a symbol that I interpret as "Turn...
  4. D

    Tos Trens spindle bearing lubrication

    I have an SN32 and wrestled with this a long time.. Eventually I did what that poster said, clear as much grease from the line of sight as possible. Then, with a very small copper tube on a grease gun, I rolled the bearings around and shot grease in between the rollers. It takes a lot of...
  5. D

    Tos SN32 Spindle Bearing Lubrication

    Anyone ever greased a Tos SN32 spindle? Anyone ever just fill the housing with oil instead? I hate to ever deviate from any manufacturer's instructions..
  6. D

    Tos SN50B

    My 1994 SN32 has a clutch and disc brake. I assume you mean a foot brake. The spindle is engaged by pushing the lever down or up which actuates the clutch. When you move the lever back to the center position, the brake is engaged. If the spindle doesn't stop quickly then the brake needs...
  7. D

    Tos SN32 Spindle Bearing Lubrication

    I want to grease my Tos lathe spindle bearings. It is a 1994 SN32. I removed the access cap on top of the housing but there is not enough room to get grease into the rollers. Do I need to remove the spindle nose and slide the housing forward on the ways to access the bearings or is there an...
Back
Top