What's new

Search results

  1. S

    Canned Cycle Drilling on G19 Plane with Right Angle Head

    Thanks, I normally will just put the G80 to cancel the canned cycle but, saw someone do it on another page. I apreciate the suggestion and will take a look at that parameter.
  2. S

    Canned Cycle Drilling on G19 Plane with Right Angle Head

    Good afternoon I am hoping that someone could let me know why this canned cycle will just rapid instead of feeding to the depth of the hole? 2022 Takumi 3 Axis Mill Fanuc Oi Control I have a right angle head setup and my drilling in the G19 plane % O1111(RA DRILL CYCLE) G20 G00 G17 G40 G49...
  3. S

    2006 Daewoo DMV 4020D Fanuc 21i-MB - Rotary 4th axis question

    I purchased a used machine that has a 4th axis drive installed but, came without the rotary. I would like to install a rotary and would like to know if it's possible that a SMW 4th axis with a 22pin and 17pin connector will work? Is there any way to see in the parameters or ladder for the type...
  4. S

    Machining Polyurethane

    Did you ever figure out a way to machine the Polyurethane?
  5. S

    machining rubber

    I was wondering if you figured out how to machine your part? I have some parts that are 75 Shore A and trying to figure the best way to machine it
  6. S

    x axis coordinate shifting after running program?

    HI, Problem - I have been running production on some parts and have come the end of the run when all of a sudden the parts are shifting somewhere during the program. The fixtures are rigid and its machining aluminum. The shift is moving in 1 direction around .050" to .100" every run. Question...