What's new

Search results

  1. M

    Aloris tool post repair

    I found some good info on YouTube the wedge type that piece on top unscrews. I keep putting oil in it. I put it in a Vice and kept hitting with a punch & hammer. Oil the hole in the bottom. turn it upside down and oil the bottom threads that helped a lot because you’re unscrewing it from the...
  2. M

    Any way to adjust the handle on my Aloris Tool Post?

    If it’s the wedge tool holder make sure both wedges are the same height. Also did you mark them so you put them back in the same slots that came out of. Now if one wedge is lower than the other you’ve got it indexed wrong. that’s a three lead screw on the center you screw out. it’ll go in...
  3. M

    Lathe chuck sizing

    Just turn the jaws around. screw them and out turnaround. then you can hold a bigger piece I used to do it all the time
  4. M

    Hardinge HC

    Yeah I know. read it again before you talk condescending to someone that knows what they’re talking about. that’s why I said that it’s much better to drill a hole with using a tail stock. Ive been a machinist 25 + years. I never said in HC had a tail stock. I Even ask him which way was...
  5. M

    Hardinge HC

    Speed the spindle up when you center drill it. You won't have much feel with the dial. Tail stock is much better. Is it off up and down or forward and back to you in the Y direction?
  6. M

    Summit Large Bore Lathe For Sale $5,500 obo

    Where are you located? . Where are you located
  7. M

    turret lathe tooling

    Can the Hardinge turret lathes be converted to a compound cross slide?
  8. M

    Trade large endmills for small endmills

    I have some high speed and some cobalt large 3/4" - 1" diameter endmills I would trade for some smaller 1/8"-1/2" diameter cutters. 2 flute, 4 flute and some roughing cutters. From 2 inches to 5 inches. Some are New, some are hardly used and some are sharpened. Most are in the cardboard...
  9. M

    Anybody want to trade??

    I have some high speed and some cobalt large 3/4" - 1" diameter endmills I would trade for some smaller 1/8"-1/2" diameter cutters. 2 flute, 4 flute and some roughing cutters. From 2 inches to 5 inches. Some are New, some are hardly used and some are sharpened. Most are in the cardboard...
  10. M

    Phase-Craft RPC install tonight

    Is this done w/o using a starter motor?
Top