Largest Manufacturing Technology Community on the Web
Stay Connected:
Search results
-
Writing an in process probing cycle to keep the higher of two points
This is what finally worked. Thank you all for the help T30M6(PROBE) G90G80G40G17 G0G54X0.Y-1. G43H30Z2. G65P9832 (SWITCH THE PROBE ON) G65P9810X0.Y-1.Z2.F200 G65P9811Z0.(MEASURE FIRST POINT AT Y-1) #600= #187 (SET #600 TO WHAT THE PROBE MEASURED) G65P9810Y1.X0 G65P9811Z0.(MEASURE AT 2ND POINT...- IntegrityMachine
- Post #11
- Forum: CNC Machining
-
Writing an in process probing cycle to keep the higher of two points
This works as far as the machine reading the code but the values arent being stored somehow. When its finished it over writes G54 to 0.- IntegrityMachine
- Post #10
- Forum: CNC Machining
-
Writing an in process probing cycle to keep the higher of two points
I can only reach maximum two holes per setup (31" apart) before I have to unclamp the part and shift it down roughly 40 inches and start all over again, therefore I can only use two offsets at a time in the program anyway...which I'm doing. The "highest point" I am trying to achieve is on two...- IntegrityMachine
- Post #9
- Forum: CNC Machining
-
Writing an in process probing cycle to keep the higher of two points
That is exactly what I am attempting to do: probe two spots at each location and keep the higher of the two. There are five holes per part evenly spaced over a ten foot span on a 50" machine.- IntegrityMachine
- Post #7
- Forum: CNC Machining
-
Writing an in process probing cycle to keep the higher of two points
Hello everyone! First post so take it easy on me lol I have a new Haas with a renishaw probe. The goal is to create a cycle to probe two locations in Z, keeping the higher of the two and loading it in G54. I'm trying to prevent gouging the surface near a hole on either side of a key that is...- IntegrityMachine
- Thread
- Replies: 12
- Forum: CNC Machining