Largest Manufacturing Technology Community on the Web
Stay Connected:
Search results
-
T
Need PLC Program software or programmer for Mitsubishi M520AM and Model E Control
RS-232 cable wiring help Here is the wiring diagram for the R020 cable from Mitsubishi that 'should' let you read and write from a FCUA-MP10 single axis drive/control to a PC running GX Developer: My thinking was to wire a connection cable from the drive SIO port to the Tripp Lite Keyspan...- tropostudio
- Post #7
- Forum: CNC Machining
-
T
Need PLC Program software or programmer for Mitsubishi M520AM and Model E Control
Anybody familiar with Meldas controls know what Mitsubishi PLC model should be selected when connecting to 1) an M500 control and 2)the single-axis Model E (FCUA-MP10 series) control via RS-232? You'd think it'd equate to one of Mitsubishi's stand-alone PLC offerings. Can't find anything in...- tropostudio
- Post #6
- Forum: CNC Machining
-
T
Need PLC Program software or programmer for Mitsubishi M520AM and Model E Control
Vancbiker - Thanks for the info. I missed your response, and have been chasing down a number of rabbit holes to try to get this figured out. I found an old copy of Melsec PLC Software that I could run in VDOS. Kind of a PITA. I have since managed to get GX Developer v8.91W running, and am...- tropostudio
- Post #5
- Forum: CNC Machining
-
T
Need PLC Program software or programmer for Mitsubishi M520AM and Model E Control
Thanks for the link - I'll register and reach out. Machine is a Howa 320H-VCJ. 15k spindle, 3 axis, 16-tool changer, and an A-B jig changer table. The machine is far from being scrap. Frustrating to have the ability to "sort-of run" and interface with a really well-made, older machine, with a...- tropostudio
- Post #3
- Forum: CNC Machining
-
T
Need PLC Program software or programmer for Mitsubishi M520AM and Model E Control
I have a 1996 Howa VMC running on a Mitsubishi M520AM control. 3 Axis with Jig Changer, ATC, and 16 tool magazine. Lost parameters and User PLC program for the 2 Model E/FCUA single-axis amplifier/controls that run the ATC and the Magazine servos. Dead batteries, and both units are back to...- tropostudio
- Thread
- Replies: 6
- Forum: CNC Machining
-
T
Howa 320H-VJC parameters lost
I have a Howa 320H-VCJ vertical machining center with a Meldas 500M control. Parameters on the main control are fine, but batteries are dead in the Magazine control(Meldas FCUA-MP10-03)and ATC control(Meldas FCUA-MP10-06S1). After replacing batteries for the Magazine and ATC controls, I used...- tropostudio
- Thread
- Replies: 0
- Forum: CNC Machining
-
T
Moly grease replacement in old Howa 320-VCJ?
New member. I picked up a 1996 Howa 320-VCJ machining center recently. 24 years of hard use with tons of goop+chips, but critical surfaces all appear to be in good shape. Machine has been stripped and cleaned. Linear guides have been re-built with new wipers. I want to leave the ball nuts...- tropostudio
- Thread
- Replies: 0
- Forum: CNC Machining