What is the easiest way to reapply an aluminum pulley back on to an electric motor shaft?
Slip it back on? It will not slip back on. They had to use a puller to get it off.
I opposite way you took it off. Do they have a wheel pusher?
The motor shaft has a diameter of (28mm) and the pulley has...
Hi Everyone
Finally, after three weeks, I got the motor back from the shop.
I live 25 miles west of Pittsburgh Pa.
I called six motor shops and there is at least two to three week wait to have
A motor tested, and three to six months to have one rewound.
The windings in the motor are fried...
The RPC i am using is 15 hp, and starts my 7.5 hp dust collector with no problem So the RPC is not under sized.
I have one (3) wire feed into the machine of 240 volts with a selector switch for the three (3) motors, The motors for the table saw and planer work fine, so i do not think the...
Hi new member here
Need information ,or some ideas on where to start with a 3 phase motor.
The motor is on a shaper,and will start at 3000rpms and run for about 30 seconds and kick off. At 6000rpms it just knocks and will not start at all .The motor sounds like it is laboring when it does run...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.