Hello,
We're having issues getting larger parts off our surface grinder without scratching them.
We're trying our best to get all grinding compound out of any holes before removing the part and making sure the magnet has no residual mag in it when we begin to remove, but are still having...
Hello,
I'm looking for cheap tool scope similar to the link below. But when i search for something similar. I'm limited in what I find.
https://www.metromicrotech.com/collections/measurement-microscopes/products/mmt-1d-xy-tool-scope-xy-travel-min-angel-reading-6
Hello
I'm working on an application where the Bore ID and OD have .0005" total tolerance. The variation in a type III anodize does not allow me to meet this tolerance as the buildup varies from .0012 - .002". I'm looking into a post coating machining/honing/grinding operation to put the ID and...
Hey Guys,
I'm running into a problem in our shop. Currently we are making some rather large reamers .375" - 1.25" in diameter about. We've ran into a problem transporting them between operations in our shop.
Currently the process goes as follows:
Swiss
clean
grind
clean
Blanks are transported...
Have some parts here that need selective gold platting. Currently all the suppliers I've contacted cannot selective gold plate them. Was seeing if anyone new of any suppliers that do selective Galvanic gold plating?
We're also looking into buffing/blasting where to remove the gold plating from...
Hello,
I work for a company and we've been making these drills that need either one or two grooves painted with a Uniglaze Epoxy Paint. The paint is pretty thick not like your standard paint. We are trying to find away to stream line the process vor various diameter drills. Some drills we will...
Hello,
I'm working on an assembly for work where we need to put magnets into a pocket on the part we are manufacturing. The problem is that the magnet wants to stick to everything and if it goes in at an angle then it does not seat properly. I was wondering if anyone has any ideas to streamline...
Hello,
Im currently shrink fitting a 6061 aluminum shaft onto a stainless steel shaft 1" diameter I was wondering how much clearance I should have while putting the rotor onto the shaft.
For example if i heat the rotor so that it is 1.002 diameter and shrink the shaft to .9995 will this be...
Hi everyone,
Customer wants me to put a 9.75" 6061 T6 aluminum rotor onto a 1" shaft need to heat up the rotor to right around 350 f and that's where it begins to lose it's T6 temper does anyone know how long to put it in the oven to make sure I don't overheat it actually?
Hello all,
I need to heat up a 6061 T6 aluminum rotor to about 350 degrees in order to fit it onto a shaft.
doing research this seems to be around the temperature that 6061 aluminum would lose it's T6 temper.
thanks for the response
Hi guys,
First time posting on the forum I appreciate you taking the time to read this. I'm looking to shrink fit a 6061 T6 tempered aluminum rotor on to a 1" 440 C Stainless Steel shaft. I have calculated a .003" interference fit needed so that the rotor wont slip off until and am using the...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.