Makino RMC 55 CNC milling machine. Has fanuc OM controls. Machine is 100% operational. Has been gone through completely and cleaned. Has new spindle bearings. X Axis Travel: 21.6" Y Axis Travel: 12.6" Z Axis Travel: 13.8". weighs 6500 LBS. Have some tooling to go with it as well as a lot of...
Hello all. I have a voest da 210 lathe. I was looking through the manual and found an accessories page. It shows a collet chuck. The manual also shows it having a L0 nose with a metric 50? Taper inside. I doubt I will ever be able to find the actual collet chuck for it. Does anyone know if an...
Hey guys with the help of the forums and a few different designs i have put together a 10hp RPC. I have a question in regards to the neutral line and the ground line.
my setup consists of:
my main 240v single phase panel has the neutral line and grounds separated. the bare ground goes to a...
Hey guys. Iv been trying to learn as i go with my makino rmc55. It has fanuc o mate mf controls and a model L pmc
So the previous owner of this machine added a 24v air solenoid and ran a hose for an air mist setup. This solenoid cycled with the coolant on off button on the console. When i...
Hey guys. I have a makino leblonde rmc55 mill that i am getting running again. It has fanuc OM controls. I have done a lot of research on getting all the parameters backed up and it seems i can do it. I purchased one of those titan dnc boxes that magnet to the machine. It uses the rs232 port...
I just got done building my 10hp rpc and going through the balance procedure using fitchs document. I basically built this guy to run 2 different pieces of equipment. 1 is a makino rmc55 cnc mill. This mill has all power going through a transformer on the side of the machine and outputting 200v...
Hello guys. I just got my new to me rmc55 home. I finally got it wired up through the transformer on the side taking in 240 3 phase and out putting 200. The mill starts up and the screen shows all the x y z bits. I can move the x and y around with the keyboard but i cant seem to get the spindle...
Hello guys. I just thought id share my rpc build. I did quite a bit of research and reading on here before starting my build. I want to start out by saying thanks to those who have posted designs and schematics. It has been a huge help.
I picked up a cnc makino leblonde rmc55 mill in an...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.