I would like to say to anyone that has the Purple Grease to just dump it and replace with the Kluber/Summit Syngear SH-1150 asap! Not cheap at @$350.00 for 5 gallons but far cheaper than a damaged machine!
Well I didn't but the Haas tech did. I helped a little here and there but he was...
I just wanted to pass this information to possible save your machine from premature wear. We have a VF6 and a VF2 that just turned 2 years old. Almost two months ago I started getting a 2082 alarm.
(image below shows the grease plugs)
"2082 RESIDUAL PRESSURE DETECTED PRIOR TO AXIS LUBRICATION...
I wrote this macro to quickly check my spindle probe run out at anytime.
***This is for Next Generation Controller only and the mill will also need Rigid Tapping/Spindle Encoder.***
Just position the probe .5 or less to the left of a clean ground surface that is parallel with the Y axis.
Hit...
I wrote this macro to easily find the mid point of X and Y and the Z surface for the picking up of details that are irregular shapes or just difficult to pick up with the Haas Canned Probing Cycles.
***WORKS ON NEXT GENERATION CONTROLS ONLY***
-It will also give the overall sizes in the...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.