Hi all, I just wanted to share an observation about my 6_1/2" master. (Mch. No. F 3/73617X .. 1972)
I'm in the process of making the missing parts for a taper attachment for the lathe. One item is the cross slide screw which is a dual start LH acme thread and appears to be 10TPI.
But this then...
Rather than buying 10” diameter semi-finished back plate, which are quite expensive to buy in Europe. I though It would be nice to make one myself. This way I would not have to compromise with the amount of overhang from the headstock.
The rear of the chuck showing the 6 outer and 3 Inner...
Hi All,
I'm in the process of rebuilding a Demanders rotary table.
On one end there are 4x M14 tapped holes and machining that gives the impression that there is some form of bracket for mounting vertically.
If anyone has any info or pictures for such a bracket this would be greatly received...
Just finished measuring the 2x cams that I have, the Standard RH 2 Flute cam (2) and the RH Step Drill Cam (6)
Measured on a rotary table with cam rotating Clockwise when viewed from above. '0' angle is at the index pin.
10 Degree increments, dropping to 5 degree at the critical transitions...
Hi all,
I have a ZB25 but I'm missing the setting gauge. I'm therefore looking for help with the sizes so I can make a replacement.
If anyone can post the sizes as per my picture below that would be great. The rest I can scale.
Many thanks in advance.
Howie
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.