I searched through the forum for this subject but didn't find an answer. I haven't done any broaching before, but now need to add a 1/4" width slot in an aluminum hub (steering wheel hub) for my antique car. I have a hydraulic press and have watched videos and understand the basics of what's...
I did some searching on the forum but didn't find an answer to this. I finally bought some lathe change gears for my 1933 vintage 9" Junior and tried them out. I noticed that when installing the lead screw gear and tightening the nut, there was binding between the gear and lead screw bracket...
I have a 1933 vintage 9" (Junior or Heavy as I understand it) and would like to try learning to cut screw threads with it. I have change gears but still haven't acquired a thread dial yet. I notice that most of the thread dials attach with a pin into a boss on the edge of the cross feed...
I am a hobbyist and am hoping someone can help with a question on tube bending.
This is a Harbor Freight bender and I'm making up dies for the radius of bend I need. Although it bends fine, I'm finding that when bending (steel) at room temp, The radius I end up with is larger than the die...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.