They don't talk about the cam adjustment in the manual, I've juste use good trial and errors... It's not to complicated you juste need the allen big enough.
I had the same problem with mine. I think it happens when someone press to hard on one side of the press. I've straighten it up with the cam as you did. If you are at max setting on one side you can loosen the other side a bit. My press didn't had the drum, but I suppose it some kind of stop to...
First you need a back gauge (you can be precise with a good one). A cnc one will open you the possibility to gauge multiple bend fast. (As in your part). Second it help to have a second axis cnc, so you can control the depth of each bend (as in your part). More axis is further more flexible to...
Keep in mind that everything cut with air plasma will need edge prep when welding, including steel. But as snow man said it's hard to live without when you get use to even if you need to clean parts.
You could also use round corner for stainless rounded counter top chg make some i think.
It's veri close raduis of qhat you want and it's very cheap to buy.
yes but it's very limited as mechanical aspect is concern. The only part that is interesting is the intermediate (punch holder) compensation. I won't be able to send all the manual as I only have the paper version but I can send you some pics of what is important, just send me your e-mail in pm.
Hi, MonopolyGuy
I've played with mine on my promecam RG-103 but i'm not an expert. I was bending more on the right. If you measure the bed plate to the top plate you need to be identical on both side. I've played with the left eccentrics then cycle the press a few time then measure, then...
I have a line mate it's a good machine the only drawback is the sanding drum that come with it. It's hard to get rid of the ripple. It is easy to get another drum like dynabrade that is shorter in length but wider in diameter. To get rid of the ripple it is a combination of three thing that you...
You can bring an indicator and a flat cold roll piece to measure the parallelism of the ram. You indicate the ram as sliding the indicator over the die holder. Check, if possible, for leak of oil around cylinder, pump, filter. If repainted ask to see it work, if you can't walk away. Check punch...
Thanks a lot for the reply. It is sure when I cut a medium size contour the stainless did not warp, it's when I try to cut many feature inside a small contour (laser do the same thing to sheet). The sheet bulge a bit and the Initial height sensing need to be monitored. I was uniquely looking for...
Yes spv is like a vinyl film. I cut mine vinyl on top an I don't peel it off because often I need to pressbrake the parts. If I cut vinyl down there a lot of dross formation. I was thinking of maybe a laser like thc.
Hi guys,
I have a cnc plasma table and I cut often 16g stainless with spv. I use the down force technic to find first sheet height. For the first few cut it's ok but when the sheet began to expand and "bulge" the torch only push the sheet downward. Ohmic sensing is out of question due to spv...
I recently bought a victor thermal dynamic system. It's not yet installed but I had time to try there controller. I was in your situation, most of the time I cut one of part, need to cut bracket, simple square plate .. I was looking for an industrial system that is not only a controller, but a...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.